orbit controls OCM160 Betriebsanleitung Seite 55

OCM160 Precision DC Calibrator
Description:
This command sets output voltage limiting in Current function. This command operates
in conjunction with CDC:LIM:RES command. Node SOUR:CDC also selects Current
function if not already selected.
Parameters:
<DNPD>
<DNPD>
<UNIT>
·V
Remarks:
The value is stored in each preset
The value is set according to "Startup" preset after power on
The value is set to default on *RST command
Overlapped command
Example:
CDC:LIM 30.0
CDC:LIM? Response: 3.000000E+01 V
[:SOURce]:CDC:LIMiting:RESet
Syntax:
[:SOURce]:CDC:LIMiting:RESet <CPD>
[:SOURce]:CDC:LIMiting:RESet?
Description:
This command selects output voltage limitigne behavior, if was current amplitude
changed. Node SOUR:CDC also selects Current function if not already selected.
Parameters:
<CPD>
·ADJustable
·MAXimum
Remarks:
The value is stored in each preset
The value is set according to "Startup" preset after power on
The value is set to default on *RST command
Overlapped command
Example:
CDC:LIM:RES ADJ
CDC:LIM:RES? Response: ADJ
[:SOURce]:RTD[:AMPLitude]
Syntax:
[:SOURce]:RTD[:AMPLitude] <DNPD>[<UNIT>]
[:SOURce]:RTD[:AMPLitude]?
Description:
This command sets temperature in RTD function. Node SOUR:RTD also selects RTD
function if not already selected. If unit parameter is part of temperature, new unit is set.
Parameters:
<DNPD>
<UNIT>
·CEL
·FAR
·K
Remarks:
The value is set to default after power on
The value is set to default on *RST command
Overlapped command
55
Current amplitude 0-25 mA: Range 0.0 ... 100.0 (default 30.0)
Current amplitude 25.0001-50 mA: Range 0.0 ... 30.0 (default 30.0)
{V}
Voltage
{ADJustable|MAXimum} (default ADJ)
output current limiting is adjustable (see CDC:LIM:AMPL)
output voltage limiting is always maximum
Temperature at Nickel function. Default value is 100.0 °C.
{CEL|FAR|K}
degrees of Celsius
degrees of Fahrenheit
Kelvin
Orbit Controls AG
Owner's Manual