orbit controls OCM160 Betriebsanleitung Seite 47

OCM160 Precision DC Calibrator
Parameters:
<DNPD>
Remarks:
This command requires "Calibration" access
The value is set to default after power on
The value is set to default on *RST command
Overlapped command
Example:
CAL:POIN:MODE 5
CAL:POIN:MODE? Response: 5
:CALibration:POINt:SELect
Syntax:
:CALibration:POINt:SELect <DNPD>
:CALibration:POINt:SELect?
Description:
This command selects calibration points of particular mode.
Parameters:
<DNPD>
Remarks:
This command requires "Calibration" access
The value is set to default after power on
The value is set to default on *RST command
Overlapped command
Example:
CAL:POIN:SEL 1
CAL:POIN:SEL? Response: 1
:CALibration:POINt:SAVE
Syntax:
:CALibration:POINt:SAVE
Description:
This command saves current calibration point to non-volatile memory. Unsaved changes
will disappear on restart, selection of another calibration point or close the calibration.
Parameters:
None
Remarks:
The value is set to default after power on
The value is set to default on *RST command
Overlapped command
Example:
CAL:POIN:SAVE
:CALibration:SECure:EXIT
Syntax:
:CALibration:SECure:EXIT
Description:
This command exits calibration mode and access.
Parameters:
None
Remarks:
The value is set to default after power on
The value is set to default on *RST command
47
Ranges and default values varies in accordance to selected point (see
"Calibration points").
Ranges and default values varies in accordance to selected point (see
"Calibration points").
Orbit Controls AG
Owner's Manual