orbit controls OCM160 Betriebsanleitung Seite 53

OCM160 Precision DC Calibrator
[:SOURce]:VDC:RANGe
Syntax:
[:SOURce]:VDC:RANGe <CPD>
[:SOURce]:VDC:RANGe?
Description:
This command selects range in Voltage function. Node SOUR:VDC also selects Voltage
function if not already selected.
Parameters:
<CPD>
·AUTO
·100V
·30V
·3V
·300MV
Remarks:
The value is stored in each preset
The value is set according to "Startup" preset after power on
The value is set to default on *RST command
Overlapped command
Example:
VDC:RANG AUTO
VDC:RANG? Response: AUTO
[:SOURce]:VDC:LIMiting[:AMPLitude]
Syntax:
[:SOURce]:VDC:LIMiting[:AMPLitude] <DNPD>[<UNIT>]
[:SOURce]:VDC:LIMiting[:AMPLitude]?
Description:
This command sets output current limiting in Voltage function. This command operates
in conjunction with VDC:LIM:RES command. Node SOUR:VDC also selects Voltage
function if not already selected.
Parameters:
<DNPD>
<DNPD>
<UNIT>
·A
Remarks:
The value is stored in each preset
The value is set according to "Startup" preset after power on
The value is set to default on *RST command
Overlapped command
Example:
VDC:LIM 0.05
VDC:LIM? Response: 5.000000E-02 A
[:SOURce]:VDC:LIMiting:RESet
Syntax:
[:SOURce]:VDC:LIMiting:RESet <CPD>
[:SOURce]:VDC:LIMiting:RESet?
Description:
This command selects output current limitigne behavior, if was voltage amplitude
changed. Node SOUR:VDC also selects Voltage function if not already selected.
Parameters:
<CPD>
·ADJustable
53
{AUTO|100V|30V|3V|300MV} (default AUTO)
auto-range mode
fixed 100 V range
fixed 30 V range
fixed 3 V range
fixed 300 mV range
Voltage amplitude 0-30 V: Range 0.0 ... 0.05 (default 0.05)
Voltage amplitude 30.0001-100 V: Range 0.0 ... 0.05 (default 0.05)
{A}
Amper
{ADJustable|MAXimum} (default ADJ)
output current limiting is adjustable (see VDC:LIM:AMPL)
Orbit Controls AG
Owner's Manual