orbit controls OCM160 Betriebsanleitung Seite 70

Orbit Controls AG
Parameters:
<DNPD>
Remarks:
Overlapped command
Example:
STAT:QUES:NTR 2
STAT:QUES:NTR? Response: 2
:STATus:QUEStionable:PTRansition
Syntax:
:STATus:QUEStionable:PTRansition <DNPD>
:STATus:QUEStionable:PTRansition?
Description:
This comman allows set Questionable Positive Transition Register. It is a decimal value
which corresponds to the binary-weighted sum of all bits set in the register. Setting a bit
in the positive transition filter shall cause a 0 to 1 transition in the corresponding bit of
the associated condition register to cause a 1 to be written in the associated bit of the
corresponding event register.
Parameters:
<DNPD>
Remarks:
Overlapped command
Example:
STAT:QUES:PTR 2
STAT:QUES:PTR? Response: 2
:SYSTem:BEEPer:STATe
Syntax:
:SYSTem:BEEPer:STATe <BOOL>
:SYSTem:BEEPer:STATe?
Description:
This command sets state of device beeper.
Parameters:
<BOOL>
·ON
·OFF
·1
·0
Remarks:
Overlapped command
Value is not affected by reset
Example:
SYST:BEEP:STAT ON
SYST:BEEP:STAT? Response: 1
:SYSTem:BEEPer:VOLume
Syntax:
:SYSTem:BEEPer:VOLume <DNPD>
:SYSTem:BEEPer:VOLume?
Description:
This command sets the system device beeper volume.
Parameters:
<DNPD>
Remarks:
Overlapped command
Owner's Manual
Questionable Negative Transition Register, Range 0... 32767
Questionable Positive Transition Register, Range 0... 32767
{ON|OFF|1|0} (default 1)
device system beeper is enabled
device system beeper is disabled
same as ON
same as OFF
Range 0.0 ... 1.0 (Max. volume) (default 0.2)
OCM160 Precision DC Calibrator
70