Siemens SITRANS LUT400 Betriebsanleitung Seite 9

Pipe mount
enclosure with optional display lid
Note: Pipe mount fasteners not included.
Mounting the enclosure
1) Fasten the mounting back plate to the pipe using u-bolts, saddle clamps, (customer
supplied) suitable to pipe diameter.
2) Fasten bolts with a wrench. Do not over-tighten so that plate becomes twisted or bent.
This may hinder ability to clip the LUT400 to the back plate.
3) Fasten device to mounting back plate (as described in step 3 of
enclosure
on page 5).
Please note:
• Recommended mounting: directly to horizontal or vertical pipe. If alternate mounting sur-
face is used, it MUST be able to support four times the weight of the device.
• Recommended pipe dimensions: maximum: 3" pipe, minimum: 3/4" pipe
• Recommended fastener sizes:
• U-Bolts:
maximum: 3" pipe size with M8 or 3/8" thread
minimum: 3/4" pipe size with M6 or 1/4" thread
• Hex Nuts:
M6 or 1/4" to M8 or 3/8"
• Washer:
maximum: 16 mm or 13/16" outside diameter.
7ML19985XU81
mounting back plate
SITRANS LUT400 (HART)
u-bolt
saddle
clamp
pipe
Wall mounting the
Page EN-7