Siemens SITRANS LUT400 Betriebsanleitung Seite 7

enclosure with blank lid
Note: Wall mount fasteners not included.
back of enclosure
Wall mounting the enclosure
1) Mark and drill four holes in the mounting surface for the four screws (customer supplied).
2) Fasten with a screwdriver.
3) Line up slotted features on back of device with clips on mounting back plate. Press the
LUT400 flush against the back plate and slide downward to fasten in place.
mounting screw holes on back plate
7ML19985XU81
Please note:
• Recommended fastener size: M8 or 5/16"
screw with washer of maximum 17 mm or 
5/8" outside diameter
• Recommended mounting: mount directly to
wall. If alternate mounting surface is used, it
MUST be able to support four times the weight
of the device.
SITRANS LUT400 (HART)
mounting back plate
clips (2 places)
clips (2 places)
slotted features
Page EN-5