Siemens SITRANS LUT400 Betriebsanleitung Seite 26

Transducer
Specifies the Siemens transducer connected to the device.
Options
Temperature Source
Source of the temperature reading used to adjust the speed of sound.
Options
Fixed Temperature
Source of the temperature reading used to adjust the speed of sound.
Value
This parameter is only displayed if FIXED TEMPERATURE selected for
Source
.
Primary Measuring Device
Defines the primary measuring device (PMD) to be used in the application.
Options
* Option will be set to OTHER if the wizard was run previously via HART software tool
(such as SIMATIC PDM), and the device was set to OFF or UNIVERSAL HEAD VS.
FLOW. If this is initial configuration, the PMD can only be set for no calculation (OFF),
or for linearization (UNIVERSAL HEAD VS. FLOW) via HART software tools (SIMATIC
PDM, AMS, FC375/475). See full Operating Instructions.
Method of Flow Calculation
Sets the method of flow calculation.
Options
Units
Sensor measurement units.
Options
For the purpose of this example, all values are assumed to be in meters (m).
Note:
Page EN-24
NO TRANSDUCER, XRS-5, XPS-10, XPS-15, XCT-8, XCT-12, XPS-30, XPS-40,
XLT-30, XLT-60, STH
Default: NO TRANSDUCER
TRANSDUCER, FIXED TEMPERATURE, EXTERNAL TS-3, AVGERAGE OF
SENSORS
Default: TRANSDUCER
Range: -100.0 to +150.0 °C
Default: +20.0 °C
EXPONENTIAL DEVICES, RECTANGULAR FLUME BS-3680, ROUND NOSE
HORIZONTAL CR. BS-3680, TRAPEZOIDAL FLUME BS-3680, U-FLUME BS-
3680, FINITE CREST WEIR BS-3680, THIN PLATE RECT. WEIR BS-3680, THIN
PLATE V-NOTCH WEIR BS-3680, RECT. WEIR CONTRACTED, ROUND PIPE,
PALMER BOWLUS FLUME, H-FLUME, OTHER
Default: EXPONENTIAL DEVICES
ABSOLUTE, RATIOMETRIC
Default: ABSOLUTE
M, CM, MM, FT, IN
Default: M
SITRANS LUT400 (HART)
Temperature
*
7ML19985XU81