Siemens SITRANS LUT400 Betriebsanleitung Seite 8

Remote mounted lid
remote display lid
4 panel mount
fasteners provided
Mounting the remote lid
Note: Remote mounted lid can be mounted up to 5 m from the device using two
optional cable extensions (each 2.5 m in length). See full Operating Instructions.
1) Using the template provided, cut out the necessary hole for the remote LUI display lid.
Place the gasket inside the lid, aligning the mounting holes. Align the back of the remote
display lid with the panel hole cut-out. Mark and drill four holes in the mounting surface
for the four screws (provided).
2) Fasten with a screwdriver and wrench.
Note: Recommended torque on fastening screws for good seal:
• 1.1 N m
• 10 in-lbs
Please note:
• Recommended mounting: mount to panel, up to 5 m from the device. If alternate mounting
surface is used, it MUST be able to support four times the weight of the device.
Note: Fasteners included: M5 screw, seal washer, M5 flat washer and nut. These
fasteners are required to maintain IP65 rating on remote lid.
Page EN-6
gasket
SITRANS LUT400 (HART)
extension cable
SITRANS LUT400
7ML19985XU81