Siemens SITRANS LUT400 Betriebsanleitung Seite 22

Response Rate
Sets the reaction speed of the device to measurement changes in the target range.
Notes:
• Response Rate can only be set through the Quick Start Wizard, and any
changes made to Fill Rate per Minute (2.3.1.), Empty Rate per Minute (2.3.2.), or
Damping Filter (2.3.3.) parameters following the completion of the wizard will
supersede the Response Rate setting.
Response Rate
•
Options
Use a setting just faster than the maximum filling or emptying rate (whichever is
greater). Slower settings provide higher accuracy, faster settings allow for more
rapid level fluctuations.
End of QS Level Wizard
For QS to be successful, all changes must be applied.
Options
To transfer Quick Start values to the device and return to Program menu, press
DOWN arrow
Measurement mode.
1.1.2. QS Volume
Use this wizard to configure volume applications employing standard vessel shapes.
a) Press RIGHT arrow
MENU.
b) Press RIGHT arrow
c) Press DOWN arrow
d) At each step, press DOWN arrow
values and move directly to the next item, 
or RIGHT arrow
selection is highlighted.
e) Scroll to desired item and press RIGHT arrow
store the change, then press DOWN arrow
continue.
f) At any time, you can press UP arrow
LEFT arrow
Page EN-20
always displays in m/minute.
SLOW (0.1 M/MIN)
MEDIUM (1.0 M/MIN)
FAST (10 M/MIN)
Default: SLOW (0.1 M/MIN)
BACK, CANCEL, FINISH 
(Display returns to 1. 1 Quick Start menu when Quick Start is successfully com-
pleted or cancelled. If CANCEL is selected, no changes are written to the
device.)
(Finish). Then press LEFT arrow
to activate PROGRAM mode and open menu level 1: MAIN
two times to navigate to menu item 1.1.1.
and RIGHT arrow
to open Edit mode: the current
to cancel the wizard.
SITRANS LUT400 (HART)
three times to return to
to open QS Volume.
to accept default
to
to
to go back, or
QUICK START VOLUME
TRANSDUCER
XRS-5
BACK
CANCEL EDIT
NEXT
QUICK START VOLUME
TRANSDUCER
NO TRANSDUCER
XRS-5
XPS-10
XPS-15
XCT-8
XCT-12
7ML19985XU81