Edit View; Program Mode - Siemens SITRANS LUT400 Betriebsanleitung

Parameter view
menu in
SENSOR
which
UNITS
parameter SENSOR MODE
SENSOR MODE SECONDARY
is located
TRANSDUCER
FREQUENCY
parameter
name

PROGRAM mode

Using the device local push buttons, press
Scroll through the menu using
Selecting a listed option
a) Navigate to the desired parameter.
b) Press RIGHT arrow
c) Scroll to a new selection.
d) Press RIGHT arrow
the new selection.
Changing a numeric value
a) Navigate to the desired parameter, for example, Low Calibration Point (2.2.1.).
b) When selected, the current value is displayed.
c) Press RIGHT arrow
position is highlighted.
d) Use LEFT
digit position you wish to change.
e) As each digit is highlighted (selected), use the UP
increase or decrease the digit respectively.
f) While decimal point is selected, use UP
position.
g) To escape without saving your changes, press LEFT arrow
is highlighted. Press LEFT arrow
Otherwise, when new parameter value is correct, press RIGHT arrow
continually until OK is highlighted.
h) Press RIGHT arrow
and displays the new selection. Review for accuracy.
Page EN-16
2.1.6
XRS-5
, , ,
to open Edit mode. The current selection is highlighted.
to accept it. The LCD returns to parameter view and displays
to open Edit mode. The cursor
and RIGHT arrow
to accept the new value. The LCD returns to parameter view
SITRANS LUT400 (HART)

Edit view

parameter
TRANSDUCER
NO TRANSDUCER
number
XRS-5
XPS-10
XPS-15
parameter
XCT-8
value/
XCT-12
selection
XPS-30
to enter Program mode and open menu level 1.
.
to move cursor to
and DOWN arrow
and DOWN arrow
again to escape without saving changes.
2.1.6
LOW CALIB. PT.
2.2.1
ESC + _ _ _ _ _ _ 2. M 0 OK
to
to shift decimal
continually until ESC
7ML19985XU81