Siemens SITRANS LUT400 Betriebsanleitung Seite 33

Run Time Relay 2
Set the amount of time that pump Relay 2 has run, defined in hours.
Value
Use the default value for new pumps, or set this value for existing pumps with
accumulated run time. (This parameter displays only if a Service Ratio algorithm is
selected for Pump Control Mode.)
Run Time Relay 3
Set the amount of time that pump Relay 3 has run, defined in hours.
Value
Use the default value for new pumps, or set this value for existing pumps with
accumulated run time. (This parameter displays only if a Service Ratio algorithm is
selected for Pump Control Mode.)
ON Setpoint Pump 1
The level at which Pump 1 turns ON, defined in 2.1.1.Units.
Value
ON Setpoint Pump 2
The level at which Pump 2 turns ON, defined in 2.1.1.Units.
Value
OFF Setpoint Pump 1
The level at which Pump 1 turns OFF, defined in 2. 1 . 1 .Units.
Value
OFF Setpoint Pump 2
The level at which Pump 2 turns OFF, defined in 2. 1 . 1 .Units.
Value
End of Wizard - Pump Control
For Wizard to be successful, all changes must be applied.
Options
To transfer values to the device and return to Program menu, press DOWN arrow
(Finish). Then press LEFT arrow
7ML19985XU81
Range: 0 to 999999
Default: 0
Range: 0 to 999999
Default: 0
Range: 0.000 to 99999.000
Default: 0.000
Range: 0.000 to 99999.000
Default: 0.000
Range: 0.000 to 99999.000
Default: 0.000
Range: 0.000 to 99999.000
Default: 0.000
BACK, CANCEL, FINISH (Display returns to Pump Control menu when Wizard
is successfully completed or cancelled. If CANCEL is selected, no changes are
written to the device.)
SITRANS LUT400 (HART)
two times to return to Measurement mode.
Page EN-31