Replacing The Filter Pc Board - Symofil - Fronius Symo 10.0-3-M Serviceanleitung, Ersatzteilliste

Replacing the fil- Removing the SymoFIL:
ter PC board -
SymoFIL
(2)
(4)
Inserting the SymoFIL:
(3)
(1)
WARNING!
Observe the safety rules (see the begin-
ning of the "Safety" section)
Take the inverter out of the wall bra-
1
cket and remove the Recerbo without
detaching the device data unit (see
"Opening and closing the device",
"Replacing the display PC board -
Recerbo" and necessary „Replacing
the Overvoltage PC board" sections)
(2)
Undo the 4x9 TX20 screw (1) on the
2
ground connection
Undo the two 5x10 TX25 screws (2)
3
and remove the Datcom insert
Disconnect all cables and plug connec-
4
tions (3) from the SymoFIL and thread
them out
Undo the nine 4x9 TX20 screws (4)
5
Thread out the SymoFIL and remove it
6
155