Replacing The Filter Pc Board - Primofil - Fronius 10.0-1 Serviceanleitung

Replacing the fil- Removing PrimoFIL:
ter PC board – Pri-
moFIL
(2)
(3)
(1)
(4)
(5)
WARNING! Follow the safety
rules (see start of "Safety" chap-
ter)
Remove the inverter from the wall bra-
1
cket, open, and remove the Recerbo
without dismantling the snap-off PC
board (see "Opening and Closing the
Device", "Replacing the Display PC
Board (Recerbo)" and necessary
„Replacing the Overvoltage PC board"
sections)
Loosen 1 screw 4x9 TX20 (1) of the
2
ground connection
(2)
Loosen 2 screws 5x10 TX25 (2) and
3
remove the Datcom insert
Loosen all cable and plug connections
4
(3) from the PrimoFIL and pull out
Loosen 9 screws 4x9 TX20 (4)
5
Pull out and remove the PrimoFIL
6
Unplug jumper on the underside of the
5
PrimoFIL
139