Protecting Yourself And Others; Emc Measures; Data Protection; Obligations Of The Operator - Fronius USB Update Active Inverter Bedienungsanleitung

Protecting your- While the charger is in operation, keep all persons, especially children, out of the working
self and others
area. If, however, there are people in the vicinity,
-
-
Before leaving the work area, ensure that people or property cannot come to any harm in
your absence.

EMC measures

In certain cases, even though a device complies with the standard limit values for emis-
sions, it may affect the application area for which it was designed (e.g. when there is sen-
sitive equipment at the same location, or if the site where the device is installed is close to
either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate action to rectify
the situation.

Data protection

The user is responsible for the safekeeping of any changes made to the factory settings.
The manufacturer accepts no liability for any deleted personal settings.
Obligations of the
The operator must only allow persons to work with the device who:
operator
-
-
-
Checks must be carried out at regular intervals to ensure that operators are working in a
safety-conscious manner.

Safety inspection

The manufacturer recommends that a safety inspection of the device is performed at least
once every 12 months.
A safety inspection should be carried out by a qualified electrician
-
-
-
-
For safety inspections, follow the appropriate national and international standards and di-
rectives.
Further details on safety inspections can be obtained from your service centre. They will
provide you, on request, with any documents you may require.
Markings on the
Devices with the CE marking satisfy the essential requirements of the applicable guide-
device lines.
Devices displaying the EAC mark of conformity satisfy the requirements of the relevant
standards in Russia, Belarus, Kazakhstan, Armenia and Kyrgyzstan.
20
warn them about all the dangers (hazardous acids and gases, danger from mains and
charging current, etc.),
provide suitable protective equipment.
are familiar with the fundamental instructions regarding safety at work and accident
prevention and have been instructed in how to use the device
have read and understood these operating instructions, especially the section "safety
rules", and have confirmed as much with their signatures
are trained to produce the required results.
after any changes are made,
after any additional parts are installed, or after any conversions,
after repair, care and maintenance has been carried out,
at least every 12 months.