Replacing The Display Pc Board - Recerbo - Fronius Symo 10.0-3-M Serviceanleitung, Ersatzteilliste

Replacing the dis- Removing the Recerbo:
play PC board -
Recerbo
Observe the safety rules (see the beginning of the "Safety" section)
Installing the Recerbo:
1
NOTE!
If you forget to connect the device data unit or do not connect it correctly, the invert-
er will show status code 482 on the display
WARNING!
(1) (1)
(3)
Break off the device data unit from the new Recerbo
Take the inverter out of the mounting
1
bracket, open it and remove the Data-
manager card (see "Opening and clo-
sing the device" and "Replacing the
Datamanager card" sections)
Disconnect all connections from the
2
Recerbo
Push the Recerbo holder locking de-
3
vices (1) upwards
Remove the Recerbo module
4
NOTE!
(2)
Take care not to damage any of the com-
ponents when carrying out the next two
steps
Take the holder (2) off the Recerbo
5
Break off the device data unit (3) from
6
the faulty Recerbo
153