Replacing The Eco Dc Disconnector - Fronius Symo 10.0-3-M Serviceanleitung, Ersatzteilliste

Replacing the Removing the DC disconnector:
Eco DC discon-
nector
134
(1)(2)
(1)(2)
Insert the control switch and shaft (2)
3
and secure it using the retaining clip (1)
WARNING!
Take safety precautions.
Observe the safety rules - DC voltage pre-
sent!
Connect the AC and DC lines to the
4
terminal block of the DC disconnector
Place the inverter in the mounting bra-
5
cket (see "Opening and closing the de-
vice")
WARNING!
Observe the safety rules (see the begin-
ning of the "Safety" section)
Remove the inverter from the mounting
1
bracket (see "Opening and closing the
device")
WARNING!
Take safety precautions.
Observe the safety rules - DC voltage pre-
sent!
Disconnect the AC and DC leads from
2
the terminal block of the DC dis-
connector
Remove the retaining clip (1) and con-
3
trol switch with shaft (2)