Undo the two 5x10 TX25 screws (2)
3
and remove the Datcom insert
(5)
Inserting the EcoFIL:
(5)
Disconnect all cables and plug connec-
4
tions (3-4) from the EcoFIL and thread
them out
Undo the nine 4x9 TX20 screws (5)
5
Thread out the EcoFIL and remove it
6
Remove the protective film from the
1
thermally conductive pad fort he new
EcoFil PC board and ensure that the
pads do not slip out of place or fall off
during installation.
Thread in and position the new EcoFIL
2
Fit the EcoFIL with nine 4x9 TX20
3
screws (5)
[2 Nm]
157