Inhaltsverzeichnis
Werbung
2
_To
install bagger components to tractor
1
1. Discharge Chute
2. 3/8 Nut
3.
Rat Washer
1.
2.
3.
4.
5.
3
SupportBracket
3/8 Carriage Bolt
3/8 LookNut
1
3/8 x 63,5mm Hex Bolt
lO,3mm (13/32')
flat
washer
5
2
•
Removedischarge chutefromrearoftractor.Unhookthe
two(2) strapsand pullchuteout and awayfrom tractor.
Removethe two (2) 3/8 nuts and fiatwashersfrom the
boltsat the tractorbackplate.
1. 3/8 Lock nut
2.
FlatWasher
3. SupportTube
•
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
•
Install the two upper support brackets through the back
plate and to the chassis, usingthe 10 x 19 mm (3/8"x3/4")
carriage bolts and Iocknuts supplied. Tighten securely.
•
Assemble both support brackets to the outside of the
baggger support tuba using two each 3/8 x 63,5mm hex
bolts13/32" I.D. flat washers and 318 Iocknuts from parts
bag. Tighten securely.
1.
Hook
2.
Discharge Chute
3.
Back plate slot
3
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
23
Werbung
Inhaltsverzeichnis
