Getting Started; Powering On/Off; Powering On With Emergency Button; Powering On With Transmit Inhibit Active - Motorola Cleartone CM5000 Bedienungsanleitung

Getting Started

Powering On/Off

To power On, press and hold the rotary knob. The CM5000
performs a self-check and registration routine. After
successful registration, the CM5000 is in service.
To power
Off,
You hear a beep and the Powering Off message is
displayed.

Powering On with Emergency Button

Press and hold the Emergency button to power On. The
CM5000 powers On in Emergency Mode or in standard
mode (as programmed).

Powering On with Transmit Inhibit Active

Transmit Inhibit (TXI) is a feature allowing you to switch off
transmission before entering a Radio-Frequency (RF)
sensitive area. To activate this feature, press the Menu
button and select More...> Networks > TXI Mode >
Activate.
Warning:
! !
Pressing the Emergency button, even if Transmit Inhibit is activated,
causes the CM5000 to transmit immediately. The CM5000 must NOT
be within the RF sensitive area when entering Emergency Mode.
The TXI Mode remains active at power On. You are
prompted whether to leave the TXI Mode On or not.
Warning:
! !
Ensure you have left the RF sensitive area before deactivating Transmit
Inhibit.
Press the Yes soft key to deactivate the TXI Mode. If the
CM5000 was previously used in Trunked Mode, it will register
to the network. If the CM5000 was previously used in Direct
Mode, it will remain in Direct Mode.
Press No in Trunked Mode and the CM5000 powers down.
16
press and hold the rotary knob push button.