Fault Detection And Troubleshooting; Notes On Troubleshooting; Fault And Action Table - HUPFER KSPA-3 Betriebsanleitung

Chapter 6
Page 20
6

Fault Detection and Troubleshooting

6.1

Notes on Troubleshooting

Please contact our service partners in case of malfunction and complaints within the warranty period. Even
after the warranty period is expired you can have necessary repair work done by our service partners and
certified electricians.
Service work should only be carried out by authorised specialists.
Defective components should only be replaced with
the replacement of individual components.
In the event of after-sales service and when ordering spare parts, always specify the data and corresponding
part number indicated on the rating plate.
Regular inspection and maintenance of the appliance prevent disruptions to operation and ensure safety.
6.2

Fault and Action Table

Fault
Cooling is not sufficient
Running noise of swivel casters
Cold Food Mobile Bain Marie
KSPA-2 | KSPA-3
®
HUPFER original parts. The modular design simplifies
Possible cause
Cabinet door is not closed properly
Cold storage plates slightly defrosted
Stored food too warm (temperature
higher than 50°F [10°C])
Ambient temperature too high
Defective seal
Cold storage plate untight
Cold storage plates with a lower
freezing temperature have been
inserted
Defective caster bearings
Sticky surface of the casters
Fault Detection and Troubleshooting
Notes on Troubleshooting
Action
Close the cabinet door
Insert frozen cold storage plates
Only insert food that has already
been cooled
Check the condition of the cold stor-
age plates at short intervals and
replace them, if necessary
Replace seal
Replace cold storage plate
Only use cold storage plates from
®
HUPFER
Replace the swivel casters
Clean the swivel casters with water
4330040_A2