Transport, Putting Into Operation And Decommissioning; Transport; Putting Into Operation - HUPFER KSPA-3 Betriebsanleitung

Chapter 4
Page 16
4

Transport, Putting into Operation and Decommissioning

4.1

Transport

ATTENTION
The cold food mobile bain marie is delivered in a fully assembled condition.
When loading, use only hoists and load lifting devices approved for the weight of the cold food mobile bain
marie. Only the transport vehicles may be used that are approved for the weight of the appliance.
According to the valid purchase contract, the scope of delivery is specified in the shipping documents at-
tached to the delivery item.
4.2

Putting into Operation

Remove the original packing and check, whether the appliance is complete and undamaged. In no case put
a defective appliance into operation and inform the supplier immediately.
Always place the cold food mobile bain marie on firm and level floors when unpacking and operating it. Apply
the total brakes on both swivel casters to secure the appliance against rolling away.
INFO
The cold food mobile bain marie should be thoroughly cleaned with a soft cloth before putting it into opera-
tion for the first time. Before the appliance is put into operation it must be clean and dry.
The functioning of the total brakes must be checked before putting it into operation.
Cold Food Mobile Bain Marie
KSPA-2 | KSPA-3
Transport, Putting into Operation and Decommissioning
Appliance damages caused by improper transport
In the case of off-site transport in a vehicle such as a lorry, the appliances
should be secured properly. The total brakes are not sufficient as a transport
securing method.
If the appliances are not secured properly, there is a risk of damage to proper-
ty and persons caused by squashing.
During transport, secure all the individually standing appliances using corre-
sponding transport securing devices.
Disposal of packing material
The packing consists of recyclable materials and can be disposed of appro-
priately. Thereby, the different materials are to be separated and disposed in
an environmentally compatible manner. In any case, the local bodies respon-
sible for disposal are to be involved for this purpose.
Transport
4330040_A2