Resetting Parameters To Default - Mettler Toledo RA-510M Bedienungsanleitung

Auto Start: Selecting this function you can enter parameters for a sample which should be
measured more than once. As a result, after the first measurement you initiate, the following
are started automatically.
-FUNCTION-
7.Option
Interval Time:[ 60]min
Meas.Times
– Enter the number of measurements, e.g. 3. If you enter 0, measurements will be performed
until the result memory of the method is full, in other words you must stop the measurement
operation with the Reset key.
8.9 Resetting parameters to default (function 8: Mem All Clr.)
With this function you can clear all result memories and entries you have made: This
initializes the default parameters (see Section 7.1), including the date and time (function 5).
-FUNCTION-
8.Memory All Clear
Press ENTER, turn OFF Power
and turn ON again.
All parameters can be
initialized by those steps
Note: If you press any key before you switch off the instrument, the parameters will not be
reset.
RA-510M
METTLER TOLEDO
:[ 0]
– Enter the time interval, e.g. 5. The
instrument waits 5 minutes between 2
measurements. If you enter 0, the next
measurement is performed immedi-
ately.
– Press ENTER,
– switch off the instrument and then
switch on again:
"–INITIALIZE–" then flashes for a
brief time in the standard display.
Functions
27