8.2
Data transfer to PC
- Configure the infrared interface of the Densito 30PX as follows (Interface, see
chapter 5.6):
Interface:
Baud rate: 9600
Parity:
Stop Bits:
Data Bits: 8
- Connect the infrared adapter to an available serial interface (COM1, COM2,
...) on the PC.
- Insert the accompanying HelloCD™ into the CD-ROM drive of the PC.
- Install the PortableCapt program (Excel macro).
- Start the PortableCapt program on the PC.
- In the Excel macro: select the serial interface (COM1, COM2, ...) to which the
infrared adapter is connected.
- For further procedures see Chapter 6.7.
8.3
Data format
If RS is selected as interface, the data is transferred in the following format:
1)
Sample identification (a...z, space)
2)
If result is marked (*); otherwise, space
3)
Format yyyy/mm/dd hh:mm
4)
Temperature unit (°C or °F)
5)
Number of the temperature-compensation coefficient
6)
These bytes contain only spaces, unless Comp. Density, SG, °Baumé or Conc.
is selected as the result unit
METTLER TOLEDO Densito 30PX
RS
None
1
Interface
21