Peripherals; Asu-510 Automatic Sampling Unit With Fcu-510 Flow Cell; Installation - Mettler Toledo RA-510M Bedienungsanleitung

Peripherals

9. Peripherals
9.1

ASU-510 Automatic sampling unit with FCU-510 Flow cell

You can use the ASU-510 and the FCU-510 flow cell to perform continuous measurments.
The viscosity limit for the conveyed samples is approx. 200 mPas.
9.1.1

Installation

Attaching ASU-510
Power connec-
tion cable
Mounting FCU-510
Fastener screw
Holder
RA-510M
METTLER TOLEDO
Power connec-
tion cable
Pump cable
Tube connection to ASU
Suction tube
Flow cell
Bar
– Switch off the RA-510M.
– Plug the "pump" cable into the "EXT PUMP"
socket.
– Connect the sampling unit to the power
supply using the power cable.
– Screw both tubes into the openings of the
cell.
– Remove the rubber cap of the bar.
– Place the flow cell on the prism.
– Place the holder on the cell and carefully
but firmly screw on using the fastener
screw.
The holder must now lie parallel on the flow
cell!
29