Configuring Rs232C Interface; Selecting Attached Instruments - Mettler Toledo RA-510M Bedienungsanleitung

Functions
8.7 Configuring RS232 interface (function 6: RS-232C)
If you attach a computer to the RA-510M, use this function to configure the RS232C interface
(see also Section 9.2). Select
-FUNCTION-
6.RS-232C
Baud Rate:150
2400
Parity :Even Odd
Stop Bit :1
Soft H.S.:Off On
8.8 Selecting attached instruments (function 7: Option)
With this function you must select the attached instruments and whether you wish to perform
multiple measurements.
-FUNCTION-
7.Option
Printer:
Changer: CHG-241
DA-310/300 Connect:No
Auto Start:Off
• the sample changer CHG-241M or after confirming the "OTHER" option, the sample
changer CHG-230 or the DCU-300A automatic cleaning unit,
• the attachment of the DA-300M or DA-310M density meter,
• "Auto Start: On" to perform multiple measurements.
If you confirm "OTHER" under the printer option with ENTER, the following mask appears to
configure the printer interface.
-FUNCTION-
7.Option
Baud Rate:150
2400
Parity :Even Odd
Stop Bit :1
26
300 600 1200
4800 9600
None
2
DP- GA- OTHER
OTHER
Yes
On
300 600 1200
4800 9600
None
2
– Select
• baud rate,
• parity,
• stop bit(s) and
• software handshake
with the -/Disp. key and confirm each
selection with ENTER.
– Select with the -/Disp. key and confirm
each selection with ENTER:
• The printer (DP-500 from Kyoto Elect-
ronics, GA42 from
or another one),
– Select
• baud rate,
• parity and
• stop bit(s)
with the -/Disp. key and confirm each
selection with ENTER.
METTLER TOLEDO
METTLER TOLEDO
RA-510M