H) Controlling The Vehicle - Reely Carbon Fighter II Bedienungsanleitung

h) Controlling the Vehicle

Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive too
fast at the beginning until you get used to the car's reactions. Do not make any quick and jerky movements
with the operating elements of the remote control.
Never point the transmitter aerial directly onto the vehicle. It will strongly decrease the range. The maximum
range will be achieved when the aerial of the transmitter and vehicle are both vertical and in parallel to each
other.
If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly.
When switching between forward and reverse gears, the throttle/brake lever must be put in the neutral position briefly
(neutral position = let go of lever, do not move it). If the throttle/brake lever is moved from forward to reverse directly,
the brake function of the drive is activated (vehicle will NOT reverse).
The figures below only serve to illustrate the functions; they do not have to correspond to the design of the included
transmitter!
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move, if required, correct trimming), lever is in
neutral position
2. Drive forwards, slowly pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; it does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping
4. Going forwards and then going in reverse (wait briefly between changes and leave the lever in its neutral position!)
Wait briefly
43