Programming The Speed Controller; A) Programming Of Neutral And Full Throttle Positions - Reely Carbon Fighter II Bedienungsanleitung


11.

Programming the speed controller

a) Programming of Neutral and Full Throttle Positions

For programming the neutral and full throttle positions for forward/reverse driving, proceed as follows:
• Switch on the transmitter, but leave the throttle/brake in the neutral position. Put the trimming for driving into the
centre position.
• Keep the setup button pressed and turn the speed controller on.
• When the red LED starts to flash (position of the LED, see arrow in the
figure on the right), release the setup button at once.
If you do not release the setup button once the red LED flashes,
the programming mode is activated after a few seconds. In this
case, switch off the speed controller and proceed again as
described above.
• Move the throttle/brake lever at the transmitter into neutral position
(release the lever).
• Shortly push the setup button. The green LED flashes once and a beep is emitted. The neutral position is now
saved.
The beep is generated because the brushless motor is activated for a moment. These beeps may be very
low, depending on the motor. In this case, observe the LED on the speed controller.
• Move the throttle/brake lever to full throttle for forwards driving, pull it towards the handle.
Attention!
If you do not move the transmitter throttle lever during the programming process or do not move it far
enough, the vehicle might respond to even slight movements of the transmitter throttle lever or become
uncontrollable. In that case, repeat programming.
• Shortly push the setup button. The green LED flashes twice briefly and two beeps are emitted. The full throttle
position for forward driving is stored.
• Move the throttle/brake lever to full throttle for reverse driving, push it away from the handle.
• Shortly push the setup button. The green LED flashes thrice briefly and three beeps are emitted. The full throttle
position for reverse driving is stored.
• Release the throttle/brake so that it sits in the neutral position.
• Now wait for at least 3 seconds. The setting mode is left automatically and the speed controller is ready for operation
with the new settings made.
50