Commissioning; A) Installing The Receiver Aerial Cable; B) Inserting Batteries/Rechargeable Batteries In The Transmitter; C) Taking The Transmitter Into Operation - Reely Carbon Fighter II Bedienungsanleitung



9. Commissioning

a) Installing the Receiver Aerial Cable

Now remove the car body. Remove the car body splints and take off the body upwards.
If no aerial cable is pointing from the receiver box, open the receiver box by removing the retention clips and then lifting
off the lid upwards. Guide the aerial cable from the receiver box to the side and close it again.
Guide the aerial cable through the enclosed aerial tube and plug it into the respective holder at the top of the receiver
box.
Never shorten the aerial cable! Never coil the aerial cable! This greatly reduces the range!
b) Inserting Batteries/Rechargeable Batteries into the Transmitter
Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Observe
correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment again.
Observe the enclosed operating instructions for the remote control system.

c) Taking the Transmitter into Operation

Switch on the transmitter and put the trimming for steering and driving functions into the centre positions.
If the transmitter has a dual rate function, deactivate it or set it to unlimited steering deflection.
Observe the enclosed operating instructions for the remote control system.
d) Inserting the Drive Battery into the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 9. b) and c).
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH/NiCd drive battery with 6 cells (nominal voltage 7.2 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed controller.
Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of guarantee/
warranty!
Pull off the safety clips on the retainer of the battery holder and then lift the retainer upwards from the vehicle. Insert the
drive battery into the chassis battery holder. Reinsert the attachment strut in the right orientation and reattach it with
the safety clips removed in the beginning.
41