Controlling The Vehicle - Reely NEW2 Bedienungsanleitung

i) Controlling the Vehicle
Place the vehicle on the ground. Do not reach into the engine or hold the wheels.
Move the throttle/brake lever on the remote control very carefully and drive slowly until you are familiar with
how the vehicle responds to the remote control. Do not make sudden adjustments to the remote control
levers.
If the vehicle shows a tendency to move to one side, adjust the steering trim on the remote control accordingly.
The following images are for reference purposes only and do not necessarily correspond to the design of
the remote control included with the product!
The control refers to the F/R setting on the speed controller.
1. Release the throttle/brake lever (move it to the neutral position). The vehicle should roll to a halt or stay stationary
(if necessary, adjust the throttle trim on the remote control).
2. Slowly pull the throttle/brake lever towards the handle to make the vehicle move forwards.
3. Slowly push the throttle/brake lever away from the handle to make the vehicle move backwards.
Do not switch immediately between forwards/reverse. Bring the vehicle to a standstill first before moving it
in the other direction. Directly switching to another direction may overload the drive components.
Stop driving immediately if the vehicle does not respond correctly to remote control commands. If this
occurs, the vehicle/remote control batteries may be nearly empty, or the vehicle may be too far from the
remote control.
Interference on the wireless channel (e.g. from other devices, Wi-Fi) or poor reception/transmission condi-
tions may cause the vehicle to respond incorrectly.
The receiver is powered by the speed controller/vehicle battery, therefore the vehicle may not move cor-
rectly when the vehicle battery is nearly empty (e.g. the steering servo may not work properly).
For example, the vehicle battery voltage may drop momentarily at full throttle, and the receiver may not
receive the required voltage as a result. If this occurs, the vehicle will accelerate, but the steering servo will
not respond correctly. Discontinue use immediately and use a new, fully charged vehicle battery.
If the vehicle battery is empty, wait for at least 5 - 10 minutes until the engine and speed controller have
cooled down. You can then use the vehicle again with a fully charged battery.
43