Resetting The Speed Controller - Reely Carbon Fighter II Bedienungsanleitung


12.

Resetting the Speed Controller

This function will reset all settings that were adjusted when setting up the speed controller unit can be
returned to the original factory settings.
• Switch on the transmitter. Leave the throttle/brake lever in its neutral position and do not move it.
• Switch on the speed controller (move the slider towards the setup button). The vehicle should now be ready for
operation; no LED is lit on the speed controller.
• Press and hold the setup button until the red and green LEDs flash at the same time.
• Switch off the speed controller (Move the slider away from the setup button). All settings are now reset to the factory
setting, see table in chapter 11.
For programming the speed controller, please observe chapter 11.
Important!
If a LiPo battery is used as a drive battery, check the basic settings of the speed controller for whether
undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the
LiPo battery will suffer deep discharge and be destroyed.
If an NiMH- or NiCd-drive battery is used, deactivate the undervoltage recognition.
53