Filling The Water Tank - Gastroback 42606 DESIGN ESPRESSO PLUS Bedienungsanleitung

appliance or place towels, napkins, or similar materials under or on the appliance.
If during operation liquids have run on the appliance, turn off the power immedia-
tely and unplug the power cord. Dry the appliance according to the instructions in
section ›Care and Cleaning‹.
To ensure that the thermal system and all inside pipes of the appli-
ance are pre-heated and have the required operating temperature,
the appliance shoud be prepared accordingly.
1. Fill the water tank (as described) up to the MAX-mark (1500 ml).
2. Turn the appliance on by pressing the ›on/off‹-switch and posi-
tion the steam wand towards the drip tray. The power indicator
lights red. During preheating the heating indicator lights red.
Once the appliance is ready for use, the heating indicator turns
off.
Note:
The pumping noise could be a little louder when the appliance is turned on for the
first time, because the thermal system and all inside pipes in the appliance have
to be filled with water. Once the appliance is ready for operation and the systems
are filled with water, the appliance operates quieter.
ATTENTION: When operating the appliance, always ensure that the water tank is
filled.

FILLING THE WATER TANK

1. Lift the cover of the water tank upwards. You can lift the water tank by the open
lid. Fill the water tank with clean, running cold water.
ATTENTION: When operating the appliance, always ensure that the water level in
the water tank is between the filling marks MIN (100 ml) and MAX (1500 ml). Check
the water level every time before turning the appliance on and fill with fresh water if
nessecary. Do not turn the appliance on when too little water in the tank (below the
fill mark 100 ml). Always use tap water for the appliance. Never fill the appliance
with any mineral water or distilled (demineralized) water. Do not overfill the water
tank. The content must not exceed the fill line 1500 ml.
Note:
After using the steam wand or if the appliance was in operation without any water
in the water tank, it may be that no water comes through the grouphead. In this
case, follow the steps in section ›Preparing the Appliance for Operation‹.
2. Place the filled water tank again into the appliance. Make sure that the guide
grooves on the back of the water tank are engaged the cutouts in the back of
the appliance. Press the tank down so that the water valve opens in the bottom
of the water tank.
50
MAX
MIN