Introduction; Product Description (Fig. 1-20); Scope Of Delivery - Scheppach Hp1400S Originalbetriebsanleitung

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability for
damage to the product or caused by the product arising
from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the elec-
trical regulations and VDE provisions 0100, DIN 57113
/ VDE 0113 not being observed
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.

2. Product description (Fig. 1-20)

1. Foldable guide bar with handle
1a. Philips screw guide bar
2. Throttle
2a. Throttle screw
2b. Washer
3. Exhaust pipe
4. Air filter cover
4a. Fixing screw
4b. Paper filter
4c. Foam filter
5. Petrol tank cap
5a. Fuel filter insert
6. Fuel tank
7. Engine
8. Start pull cord
9. Eccentric vibration unit
10. Base plate
11. Transport wheels
12. Chassis
12a. Hexagonal bolts chassis
12b. Washers
12c. Stop nuts
13. Base plate screws
14. Oil dipstick for engine oil
15. Fuel valve
15a. Carburettor screw
16. Choke lever
17. Bracket for transport frame
18. Flex hose
19. Belt cover
19a. Belt cover screws
19b. V-belt
19c. Adjusting nut
19d. Engine mounting screws
20. Rubber pad
21. Fastening strip
21a. Fastening strip screws
21b. Spring washers
21c. Hexagonal nuts
22. Oil drain screw for eccentric vibration unit oil
23. On/off switch
24. Spark plug

3. Scope of delivery

Item
1
12
20/21
www.scheppach.com
Quantity Designation
1x Plate compactor with engine
1x Handle
1x Chassis
1x Rubber pad with fastening
bar
1x Spark plug wrench
1x Enclosed accessories bag
1x Operating manual
GB | 31