Starting The Cutting Process With A Manual Cutting Table; Stopping The Cutting Process - struers Secotom-10 Gebrauchsanweisung

Starting the Cutting Process
with a Manual Cutting Table
Protection guard
Guide rail

Stopping the Cutting Process

34
Secotom-10
Instruction Manual
As soon as the manual cutting table is connected to the Secotom-10
the following screen appears.
The wheel speed is automatically set to 3,000rpm (the correct speed
for a 200 mm wheel). However, this is a recommendation only, the
speed can be changed if necessary.

Press the START button

Position the specimen correctly in front of the cut-off wheel.
When cutting PCB's the light in the cutting table can be used to
adjust and align the PCB.

Adjust the guide rail.

Move the specimen slowly along the guide rail towards the cut-
off wheel.
Always adjust the protection guard to a distance of about 3 mm above the
If water sensitive materials have to be cut, water can be turned off in the
The machine can be stopped at any time during the cutting process
by pressing the STOP button

.
IMPORTANT
specimen to be cut.
Note
Configuration menu.

.