Reading The Display; Reading The Display During The Cutting Process; Sleep Mode - struers Unitom-50 Benutzerhandbuch

Reading the Display

A
B
Reading the Display during the
Cutting Process

Sleep Mode

Unitom-50
Instruction Manual
The display can show various kinds of information, for example
parameters for an ongoing process. During the cutting process the
screen could look as the following example:
Heading.
A
Inverted text: cursor position.
B
Function key options.
C
The feed rate of the cut-off wheel pre-set before
Feed
starting the cutting.
Load indicator of the cutting motor. The moving black
Load
column shows the status of the cutting motor:
Inside the white area: The cutting motor can be loaded
continuously.
In the grey overload area: The cutting motor can only
be intermittently loaded. The built-in thermo fuse
might shut off the cutting motor.
Wheel Position. The actual position of the cut-off wheel measured
from the top position of the cut-off wheel.
Stop Position The pre-set stop position counted from the top
position of the cut-off wheel.
To increase the lifetime of the display, the backlight is
automatically switched off if Unitom-50 has not been used for 15
min. Press any key to re-activate the backlight.
C
11