Turning Or Replacing Steel Bands On The Cutting Table - struers Secotom-10 Gebrauchsanweisung

Error
Software message
Vibrations
No coolant during cutting
Turning or Replacing Steel
Bands on the Cutting Table
38
Secotom-10
Instruction Manual
Message
Cut length limited,
cutting table too close
to end position
Safety malfunction
Please contact Struers
The diamond layer is worn down to
the level of the metal disc
The workpiece forces the cut-off
wheel to the side when cutting.
Heavy friction causes vibrations
The level of cooling fluid is too low
The rubber foam is dry
The water outlet is clogged
The recirculation pump is
contaminated with cutting residue
During normal use, it is not uncommon for the cutting table steel
bands located on either side of the cutting area to be damaged. If the
bands are only damaged on one side, then they can be turned. If
they are very badly damaged or damaged on both sides, then they
can be replaced with new ones. These are available as accessories.

Use an Allen key to loosen the screws holding the damaged
band.

Turn or renew the damaged band.

Using the Allen key, tighten the screws to secure the cutting
table bands.
Action
The cutting table is positioned close
to the end position and the length of
the cut is automatically limited. To
increase Cut length, reposition the
cutting table closer to the front start
position.
The safety switch preventing the cut-
off wheel from starting while the
hood is open has malfunctioned.
Call a Struers service technician.
Replace with a new cut-off wheel
Cut more slowly
Refill to the recommended level
Wet the rubber foam before placing it
into the holder, the capillary action
will then keep the moisture level
constant
Remove the cooling fluid nozzles
and run the recirculation pump.
Flush the cooling fluid nozzles with
clean water before replacing
Flush the pump with clean water by
gently pressing fresh water into the
inlet tube