Incoming Inspection And Transport Damage; Claims For Damages; Returns; Device Disposal - Sutter Curis Bedienungsanleitung

9.1 Incoming inspection and transport damage

The device and accessories must be inspected for possible transport damage and defects
immediately on receipt (see scope of delivery in

9.2 Claims for damages

Claims for compensation can only be asserted if the seller and/or shipper is notified promptly. A
record of damages must be prepared immediately. The record of damages has to be submitted to
the nearest Sutter representative or directly to Sutter so that claims for compensation can be
reported to the insurer.

9.3 Returns

Use the original packaging to return a device to Sutter or a Sutter service center. If this is not
available, packaging that properly protects the device being returned is mandatory. In case of
improper packaging, liability rests exclusively with the sender. The following accompanying
documents must be included:
•
Name and address of the sender/return recipient
•
Model and device number
•
Description of the defect and, if applicable, where the defect occurred
•
The version of these instructions for use
•
A notice that the device has been properly disinfected

9.4 Device disposal

The entire packaging can be returned to the seller and is recycled as far as possible. Otherwise
dispose of the packaging as waste paper and/or household garbage.
Identification of electrical and electronic equipment according to Directive
2012/19/EU (WEEE2)
This device contains materials that must be disposed of in accordance with
environmental protection requirements. The European Directive 2012/19/EU on
waste electrical and electronic equipment (WEEE2) applies to this device.
Therefore, this device is marked with the symbol of a crossed-out waste bin on the
type plate.
You can return the device to the manufacturer/ Sutter representative. This ensures
disposal in accordance with the respective national version of the WEEE directive.
17
NOTE
When removing the irrigation pump from the
packaging, note that the device's center of
gravity is at the front.
Chapter 2).