Transportation And Packaging; Receiving Inspection; Transport Damage; Claims For Compensation - Sutter Curis Gebrauchsanweisung

CURIS Instructions for Use
®

3 Transportation and packaging

3.1 Receiving inspection

3.1.1 Transport damage

The device and accessories must be inspected for possible transport damage and defects on
receipt.
Scope of delivery: CURIS

3.1.2 Claims for compensation

Claims for compensation can only be asserted if the seller or shipper is notified promptly. A record
of damages must be prepared immediately. The record of damages has to be submitted to the
nearest Sutter representative or directly to Sutter so that claims for compensation can be reported
to the insurer.

3.2 Returns

If possible, the original packaging must be used to return a device to Sutter or a Sutter service
center. If this is not available, packaging that properly protects the device being returned is
mandatory. In case of improper packaging, liability rests exclusively with the sender. The following
accompanying documents must be included:
•
Name and address of the sender/return recipient
•
Model and device number
•
Description of the defect
•
The version of these instructions for use
•
The most recent inspection record for the safety-related inspection
NOTE
The packaging of the generator is not intended for transportation together with the foot
switch! The foot switch must be packaged separately. Shipping them together may
result in transportation damage and Sutter assumes no liability for this.
When returning or shipping an RF generator, please ensure that the membrane packaging is
correctly inserted.
The packaging can be reordered under the following article number: 98 91 19
, mains cable, instructions for use
®
5