John Bean B 2000P Betriebsanleitung Seite 56

56
E360
At least one Camera calibration required
Possible causes:
the Cameras controller board has been replaced:
the camera controller board has been
•
replaced
at least one Camera has been replaced
•
the calibration data is missing
•
the Camera cables have been swapped
•
Call technical support for the following corrective
actions:
check the connections
•
calibration procedure (C122) is required to
•
calibrate the actual position of the Cameras
with respect to the balancer reference plane.
E361
A Camera not present or not responding during
self test
The balancer controller board was not able to
communicate with the camera controller board
during power on self test.
Possible causes:
the Cameras controller board is missing or
•
damaged
the flat cable connecting the keyboard, the
•
balancer controller board and the Cameras
controller board is unplugged, damaged or
missing.
Call technical support for the following corrective
actions:
check the Cameras controller board
•
check the connections
•
re-install the Cameras controller board
•
software.
E900
Unknown machine model.
E901
The machine is not calibrated.
_
.. ..........