John Bean B 2000P Betriebsanleitung Seite 158

1
2
3
6-93
6-94
6-95
158
"OPTI LINE"
The "SET OF WHEELS 1" screen page appears
automatically (Fig. 6-93).
4
The screen page shows new items useful for moving
backwards in the Set of Wheels procedure (Fig. 6-93):
5 Select to exit the "Set of Wheels" Procedure and
5
the OPTI LINE Mode.
Nota:
6
4 Deletes the current Set and starts a new "Set of
Wheels".
The last wheel examined will be kept and
automatically proposed again as wheel number 1 of
the new Set.
Note:
1
6 RETURN to the previous step, so that you can
assign the wheel a different use in the Set.
The wheels definitively acquired in the memory
2
are represented by icons grouped in the "Wheels
Currently in the Set" box (Fig. 6-94). These icons
also show any specific mandatory position assigned:
3
Fig. 6-94
1) Wheel assigned only to right side of vehicle.
2) Wheel available for both sides of vehicle.
3) Wheel assigned only to left side of vehicle.
To continue,
Apply the appropriate identification tag to
•
the wheel valve, with the same number and
colour as the last wheel shown (Fig. 6-95).
If the wheel has not yet been removed
from the balance, you can start a new
Set of Wheels and assign the data of
the last wheel, still in the memory, to the
wheel number 1 of the new Set, without
performing the measuring run.
Starting with wheel No. 2, the key will
be available for wheel removal, as an
alternative to entry keys 1, 2 or 3 (Fig.
6-93).
.. _ ..........