John Bean B 2000P Betriebsanleitung Seite 126

A
B
C
D
E
F
G
H
I
K
M
N
O
P
Q
R
S
T
U
V
6-62
126
"BALANCE WITH RUNOUT"
6.4.6 Changing modes of operation
The selection of certain functions (Enabled /
Disabled) and the threshold settings by the operator,
influence directly the Runout reports and the
advanced functions that the machine displays on the
screens.
From the "BALANCE WITH RUNOUT" Mode you
can select custom settings for the parameters listed
below.
6.4.6.1 OPTIMA SETTINGS
(Fig. 6-62)
A) Sets the Operating Mode for the current session.
Preset value: Optima Full Diagnostic.
B) Limit (threshold) for wheel first harmonic radial
runout. Preset value: 0.7 mm.
C) Sets the rim runout measurement (if the value
is "Limit exceeded" the measurement occurs
only if the threshold is exceeded; if the value
is "Always" the measurement occurs always).
Preset value: Always.
D) Runout measurement unit selection in mm or
inches. Preset value: mm.
E) Limit (threshold) for wheel peak to peak radial
runout. Preset value: 1,5 mm.
F) The wheel data detection scan occurs always
during the first measuring run. This function
allows the exclusion of the activation of the
laser scanner in the following measuring runs, in
order to optimise the operating times whenever
it is necessary to carry out more than one
measuring run for the same wheel. By assigning
value "0" the scan occurs automatically and
only at the first measuring run, after fixing the
wheel. By assigning value "1" the scan occurs
automatically at every wheel measuring run
(Preset value).
G) Limit (threshold) for the Radial/lateral Runout of
the 1st Harmonic of the rim only. Preset value:
0.7 mm.
H) Limit (threshold) for peak to peak radial/lateral
runout of rim only. Preset value: 1 mm.
I) Set the limit value for the Tread Depth TDI. The
scale is 0 to 10 mm (0-0,400 ince). Set the value
0 or "0,00" to disable the function; no icon appears
on screen. Preset value: 1,7 mm (0,068 ince).
.. _ ..........