John Bean B 2000P Betriebsanleitung Seite 162

1
6-99
6-100
6-101
162
2
+
"OPTI LINE"
Optimise vibrations
As an alternative to the mounting recommendation
for the set of wheels to minimise the PULL, you
can select a different set-up, suggested to reduce
the vibrations (Fig. 6-99) caused by any residual
unbalance on the wheels in the Set.
Press keys 1.
•
If you follow this mounting diagram (Fig. 6-99) the
driver's side of the vehicle will benefit by feeling the
least possible vibrations.
or alternatively;
Press keys 1 and 2 to view the recommended
•
mounting option for optimising vibrations and
Pull together (Fig. 6-100).
Note: The different mounting suggestions which
can be selected are not correlated.
You must choose one of the recommended
mounting options, depending on the
priority correction requirement for the
vehicle in question.
Enter fifth wheel
(Fig. 6-101)
The Set of Wheels procedure in the OPTI LINE
mode allows the entry of a fifth wheel in the set, to
guarantee greater scope for improvement.
WHEEL No. 5
Perform the procedure as described for
•
wheel No. 2.
When you enter the 5th wheel in the Set the "SET
OF WHEELS 5" screen page appears automatically
(Fig. 6-101) and the selection of the best four wheels
is shown, with their relative positions on the vehicle,
taken from the set of five wheels processed.
Note: No further wheels can be entered in the Set.
If you try to enter another wheel the
machine starts the procedure for a new
Set of Wheels and all of the data relative
to the previous Set will be deleted.
.. _ ..........