John Bean B 2000P Betriebsanleitung Seite 134

6-70
6-71
134
(a)
(b)
1 2 3
"BALANCE WITH RUNOUT"
6.4.8 Weight usage tracking
The WEIGHT TRACKING function is available in
BALANCE WITH RUNOUT and BALANCE modes
and is for saving data relative to wheel imbalances,
or the weight mode and the weights indicated for
balancing.
Saves the data acquired at the first run, after
clamping the wheel on the balancer shaft (Power
Clamp activation).
This data is effectively acquired in the memory at the
moment when the wheel is released.
This function shows the count of all balancing
weights used up to that moment and provides a
printed report on the following options:
Weights Used in Grams, from the date of function
installation.
Weights Used in Ounces, from the date of
function installation.
Weights Used in Grams, from the date of user
zeroing of the Weight Tracking Counter.
Weights Used in Ounces, from the date of user
zeroing of the Weight Tracking Counter.
To enable the function access the "SETTINGS"
screen and select the following:
"Measurements Settings / Weight usage
tracking",
set Enabled and press "ESC".
The Weight Tracking screen page is retrieved from
the FUNCTION screen page using the key (1, Fig.
6-70).
In the WEIGHT TRACKING screen page:
(Fig. 6-71)
1: zeroes the partial table counters
2: to switch from the Partial Table to the Total
Table (a) and vice versa (b)
3: prints the Table currently on screen.
Note: key 3 is only visible if the printer is enabled.
.. _ ..........