Errors - Sick Pac50 Betriebsanleitung

Operating Instructions
8

Errors

8.1 Errors and warning messages
Display A Display B
OL OVERPRESS
UNDERPRES
ERRI GEN.ERROR
ERR2 SHORTOUTI
SHORTOUT2
OVERVOLTG
ERR3
ERR4 LOW VOLTG
ATTI SHIFT RPI
SHIFT RP2
ATT2
ADJ>LIMIT
LOCK KEYLOCKED
Table 7: Errors and warning messages
98 Operating Instructions
Errors
(indicator flashes in display segments
Status Description
Error Applied pressure > upper limit of measuring
Error Applied pressure < lower limit of measuring
Error General error
Error Short-circuit at one of the two outputs
Error Applied supply voltage > 30 V DC
Error Applied supply voltage < 17 V DC
Warning Switching point setting made by the operator
the reset point that is set. The reset point is auto-
matically set below the new switching
smallest possible hysteresis.
Displayed if the applied pressure during zero
Warning
balancing lies outside the permitted
the range
Warning Displayed if an attempt
programming mode while the input lock is active
I SICK
A and B, Table 5)
Action required
range Set pressure to within
measuring
range Set pressure to within
measuring
Contact
Remove
Make the correct setting for
the supply voltage
Make the correct setting for
the supply voltage
below Acknowledge
<enter>
point with the
Acknowledge
limit of 5% of
<enter>
is made to access the Enter the password or unlock
via 10-Link if parameter
has been locked by 10-Link
8017612/1DZP
Subject to change without
PAC50
range
range
SICK
the short-circuit
by pressing the
pushbutton
by pressing the
pushbutton
entry
/ 2022-06-23 | PAC50
notice