SICK PAC50 Betriebsanleitung Seite 84

Operating Instructions
5.5 Pressure connection via the plug connection
The plug connection is suitable
the pneumatic hose has been positioned correctly before loading the pressure switch with pressure. The rear
G 1/4female thread must be sealed using the supplied blind plug. Insert the seal for the blind plug and tighten
the blind plug using a hex key (6 mm) to a tightening
hose, press against the gray plastic ring on the plug connection
Figure 14: Plug connection for 4 mm pneumatic
Operating Instructions
Installation/Mechanical
for the pneumatic
for pneumatic hoses with a 4 mm outer diameter.
torque of 1 Nm ± 0.3 Nm. To remove the pneumatic
hose (push-in fitting, PIF)
I SICK
connection
hose (push-in fitting,
Once inserted,
and carefully take out the pneumatic
8017612/1DZP
Subject to change without notice
PAC50
Figure 14)
check that
hose.
/ 2022-06-23 | PAC50