Pressure Connection - Sick Pac50 Betriebsanleitung

Operating Instructions

5.4 Pressure connection

via the G 1/4female
Be sure to use a suitable seal. Do not install the seal using tools or pointed/sharp
sealing surfaces on the device and the measuring point are clean and intact. Only use straight (not tapered)
G 1/4male threads with the PAC50. Only use screw connections
have a maximum screw-in depth of 9 mm. Using incorrect
tilting the thread during insertion.
must not be exceeded. The unused G 1/4female thread must be sealed using the supplied blind plug. Insert
the seal for the blind plug and tighten
Figure 13: Pressure connection via the G 1/4female thread
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice
Installation/Mechanical
thread (Figure 13)
connection
You should maintain a tightening
to 1 Nm ± 0.3 Nm.
connection
objects.
that seal the external flange axially and that
threads may damage the device. Avoid
torque of 1.5 Nm ± 0.5 Nm. This value
Operating Instructions
PAC50
Ensure that the
I SICK 83