Installation/Mechanical; Mechanical Connection - Sick Pac50 Betriebsanleitung

Operating Instructions
5 Installation/ Mechanical
Ensure that there is no mechanical
observe the ambient
must not be exposed to condensation.
5.1 Installation on a mounting
The PAC50 pressure switch has an integrated fixing mechanism for installing on a mounting rail according to
DIN EN 60715 - 35 mm x 15 mm/
To install the PAC50, position the lower fixing guide on the mounting rail (see Figure 7 0) and tilt the
PAC50 up until it locks into place (see Figure 7 @ and O).
To remove the PAC50 from the mounting rail, pull the fixing clip down and tilt the PAC50 up and away from
the mounting rail.
Figure 8: Installation on a mounting
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice

Installation/Mechanical

connection
load on the pressure
conditions specified
rail
7.5 mm.
rail
connection
switch during installation.
in Section 9 (Technical data). The pressure transmitter
Operating
PAC50
Please
Instructions I SICK 79