Operation And Parameter Settings - Sick Pac50 Betriebsanleitung

Operating Instructions
7 Operation and parameter
7.1 Initialization
Once the voltage supply has been connected,
color, then 2 seconds in the warning
indications are then displayed
Display area A: "SICK"
Display area B: "PAC50" or "PAC50-LT" with variant
Display areas C2 and E2: "Firmware
The device then enters display mode.
7.2 In operation: Display mode
The measuring and switching
The device has an energy-saving mode which switches off the display ("DISC" function).
mode (DISC: OFF), the display is briefly reactivated
7.3 Info mode
Pressing the A pushbutton
for 3 seconds each (see "Parameter
SPI/FHI (settings
RPI/FLI (settings
SP2/FH2 (settings for switching point 2/ upper window limit 2)
RP2/FL2 (settings for reset point 2 / lower window limit 2)
Analog output (electrical
LOW (minimum
HIGH (maximum
The info modecan be aborted bysimultaneouslypressingthe A and V pushbuttonsor by pressingthe
pushbutton in the middle.
88 Operating Instructions
Operation and parameter
settings
all segments
color to check all segments
for 2 seconds:
version"
functions are in operation.
for a longer period (> 3 seconds) displays the following parameters
info" in Section 2). The device then switches
for switching point 1/ upper window limit 1)
for reset point 1/ lower window
output signal in mA or V)
applied pressure value that has been stored since the last reset)
applied pressure value that has been stored since the last reset)
I SICK
settings
on the display light up for 2 seconds
are functioning
PAC50-FGG
(10 seconds) when one of the pushbuttons
limit 1)
8017612/1DZP
PAC50
in the primary
correctly. The following
In energy-saving
is pressed.
consecutively
back to display mode:
/ 2022-06-23 | PAC50
Subject to change without notice