Safety - Sick Pac50 Betriebsanleitung

Operating Instructions

2 Safety

WARNING!
Failure to observe the following safety notes and warnings may result in personal injury and
material damage.
2.1 Authorized personnel
Due to their specialist training, knowledge of measuring and control technology, and experience, as well
as their knowledge of country-specific
personnel are able to perform
2.2 Intended use
The PAC50 is an electronic pressure switch for monitoring the pressure of compressed air. It must only be
used by authorized personnel
or modified in any way, any warranty
ed under the specific process conditions
2.3 General safety notes and protective
The device is only to be used if it is in perfect working
2.3.1 Electrical installation
Only authorized personnel
Electrical connections
there is no power to the system
Only operate within the specified voltage range
Only operate with the loads specified
Do not use damaged cables (risk of short-circuiting
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice
regulations and the relevant standards
the work described and detect any potential
and only in industrial environments.
claim against SICK AG shall become void. The PAC50 is only to be operat-
and ambient
measures
work
are allowed to perform
between the PAC50 and other devices may only be made and separated
in these operating
Safety
and provisions,
dangers
If the PAC50 is used for any other purpose
conditions specified in these operating
order.
the electrical installation work
instructions
or water ingress via the cable/male
Operating
PAC50
the technical
independently.
instructions.
when
connector)
Instructions I SICK 63