SICK PAC50 Betriebsanleitung Seite 89

Operating Instructions
7.4 Programming mode
7.4.1 Setting the device parameters
To switch to programming mode, the V pushbutton must be pressed for longer than 2 seconds. If the
programming mode is inactive for a long period (> 15 seconds), the device automatically
to display mode. The measuring
device is in programming
Selection:
Theparameter/menuitemto be set should be selectedfirst usingthe A and V pushbuttons.Thenote
in display area B: "SET" is helpful
To select the parameter/menu
Making settings:
The parameter value to be set is displayed
existing parameter value settings.
The parameter is set using the A and V pushbuttons and then confirmed with the
The setting becomes active the moment
pushbutton, even if the pressure
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice
Operation and parameter settings
and switching functions
mode.
in this regard.
item to be set, press the
in display area A. Display areas Cl/2
a selected
switch is still in programming
continue to run (in the background)
pushbutton in the middle.
parameter value is confirmed
mode.
Operating
PAC50
reverts back
while the
and El/2 display the
pushbutton.
by pressing the
Instructions I SICK 89