SICK PAC50 Betriebsanleitung Seite 75

Operating Instructions
4.3.4.3 Supply pressure po> p1and undershooting of
If the upper pressure value P1is undershot after the measurement starts, the measurement of dT starts.
'MEAS" will then appear in the top status
between pO and the current pressure), for dT (time period in seconds since p1was passed) and QL appear
alternately. Once tout has lapsed, "DONE" appears
appears alternately in the bottom status
The message must be acknowledged
4.3.4.4 Supply pressure po> p1and undershooting of p1and
If the upper pressure value P1is undershot after the measurement starts, the measurement of dT starts.
'MEAS" will then appear in the top status
between p1 and p2), for dT (time period in seconds since p1was passed up to reaching P2)and QL appear
alternately. When the lower (pressure) threshold P2has been undershot, the color of the display changes from
green to red (to indicate that there is a leakage).
dP, dT and QL is displayed
The message must be acknowledged
8017612/1DZP / 2022-06-231 PAC50
Subject to change without notice
Product description
line. In the bottom
in the top status
line.
by pressing -e in order to set the sensor back to measurement
line. In the bottom
"DONE" is displayed
alternately in the bottom status
by pressing -e in order to set the sensor back to measurement
before tout
line, the values for dP (pressure
line and the result of dP, dT and QL
beforet
out
line, the values for dP (pressure
in the top status
line.
Operating Instructions
PAC50
difference
standby.
difference
line and the result of
standby.
I SICK
75